Most of the hydraulic system failures are similar. That is there is a sudden or gradual loss of pressure or flow. Consequently, cylinders and motors in these systems may stop working. Any of the system components can be at fault. Possible causes of hydraulic cylinder faults and their rectification are highlighted below:
| Possible causes | Rectification |
| General | |
| Damaged/worn seals | -Replace seals |
| Excessive rod wear | -Prevent wear |
| Rod damaged | -Replace rod |
| Rod seized | -Repair |
| Faulty alignment | -Align properly |
| Broken linkages | -Replace damaged linkages |
| Loose mountings | -Tighten mounting bolts |
| Jerky movement | -Assemble piston packing correctly -Avoid heavy load at slow speed |
| No thrust | -Replace faulty piston -Prevent excessive leakage -Set PRV to correct pressure |
| Abnormal cylinder thrust | -Bleed cylinder of entrained air -Check and set cylinder cushion |
| Erratic operation | |
| Air in system | -Clean filters -Replace worn seals -Drain and flush fluid -Change system fluid -Fill reservoir to proper level -Tighten leaking connections -Bleed air from system -Replace worn shaft/seal |
| Cylinder/valve sticking/binding | -Remove dirt/gummy deposit -Remove fluid contamination -Remove worn parts -Install seals properly |
| Cylinder internal leakage | – Repair or replace worn parts –Tighten loose packing -Use medium viscosity fluid -Control fluid contamination -Control wear |
References:
Categories of malfunctions in hydraulic systems in terms of its general disturbances, and their possible causes and rectification are presented in the above books. Further, the component-wise malfunctions and their potential causes and rectification are also presented.
Joji Parambath
Director
Fluidsys Training Centre
Are you looking for a course on Pneumatics and Hydraulics?
Please visit Fluidsys Training Centre Pvt. Ltd., Bangalore, India. https://fluidsys.in
